Holes 1, 9, 10 and 18 are finished. Wanted the tees for 1 and 10, the greens for 9 and 18, to be by the clubhouse. The pano was modified from an old Links pano.
Caribou Crossing
Re: Caribou Crossing
Jim
I love how well everything blends in so naturally on #9. EXCELLENT
I love how well everything blends in so naturally on #9. EXCELLENT
Re: Caribou Crossing
Thanks, Steve! Taking my time on this one as work keeps getting in the way
Re: Caribou Crossing
Short Par 3 5th, with a bathroom even.
Re: Caribou Crossing
Jim
Not sure how deep that front bunker is but it does appear to be a challenge to get up and down from. Also love your trash and recycle bins and what I'm assuming is a restroom in the distance.
I've been pretty busy and unable to do your request about rock wall design. In the utilities section of PGA 2000 under design section is 2 Copyright Club Tutorials that may be able to help in that area. I know if you experiment with the architect by making a hill say 30' high then create a shape of your choosing then to move that shape over the raised area, flatten on max height then move that shape so its slightly behind front of the max shape then flatten on average height then follow the same procedure as before moving shape slightly to the front area of average height area and flatten on lowest setting this should be the start of what you're looking to create. Hope these suggestions help.
Not sure how deep that front bunker is but it does appear to be a challenge to get up and down from. Also love your trash and recycle bins and what I'm assuming is a restroom in the distance.
I've been pretty busy and unable to do your request about rock wall design. In the utilities section of PGA 2000 under design section is 2 Copyright Club Tutorials that may be able to help in that area. I know if you experiment with the architect by making a hill say 30' high then create a shape of your choosing then to move that shape over the raised area, flatten on max height then move that shape so its slightly behind front of the max shape then flatten on average height then follow the same procedure as before moving shape slightly to the front area of average height area and flatten on lowest setting this should be the start of what you're looking to create. Hope these suggestions help.
Re: Caribou Crossing
Thanks, Steve. Will look into that. In the meantime:
Re: Caribou Crossing
Jim!
Keep up the good work!
Keep up the good work!
Re: Caribou Crossing
Uploading Caribou Crossing.
Front: 3577 yds - Par 36
Back: 3495 yds - Par 37
7072 yds - Par 73
Front: 3577 yds - Par 36
Back: 3495 yds - Par 37
7072 yds - Par 73