Hey all,
I was wondering if there is some trick to using the rotate tool. It takes me forever to rotate one object because I can never find the little dot that is supposed to appear that shows the point you are rotating around. I've tried zooming out and searching around the entire plot, but I can never find it. Is there something I need to do to get it to appear, or is there any other tips you guys might have for me in regards to the rotate tool. Thanks!
Rotate Tool
-
spencerturner
- Scratch Golfer
- Posts: 127
- Joined: November 18th, 2010, 5:11 pm
Re: Rotate Tool
Click and highlight the object you want to rotate. Then clickon the rotate tool and go to View and at the bottom click on center rotate orgin. Then rotate with your mouse. Spence.
Re: Rotate Tool
With the rotate tool active, hitting Ctrl-C will do the same thing if I'm not mistaken. Or maybe Ctrl-Shft-C??
Re: Rotate Tool
Awesome, I knew there had to be something simple I was missing. Saved me hours, thanks!
Re: Rotate Tool
After you see the center rotate origin you can left click and hold then drag to where you need it. This is good if you want to tightly rotate a bunker.
Re: Rotate Tool
Nice, I was having this same problem.
"It is all good and well to punish a bad shot, but the right to eternal punishment should be reserved for a higher tribunal than a Green Committee." Bernard Darwin on Pine Valley Golf Club.