Golf Sim Clubhouse Forum

This problem has cropped up while playtesting Buffalo Trace. Every chip-in from off the green is indicated as out of bounds. I've never seen this before and I'm rather baffled.

Jim! The only thing I can think of to tell you is to open your architect file and see if you have somehow made an OB in that area. Maybe even remove all OB's on the course then test it.

Hey, Steve. That is what is weird, is I haven't created any OB on the course.

Jim!
Can you redesign that hole? Can you move the green or move the tee area and angle of the hole? Or shorten the hole or dogleg it then test play again? Did you trim the extra off the course and get to close to that green?

After rebooting, I've not had this issue. Though I haven't tried chipping in from all textures. Unfortunately, my virtual chipping is no better than my IRL chipping

Good to hear its corrected.