BRIAN Z!

Help with questions or problems.
Post Reply
ADC
Tour Contender
Posts: 305
Joined: November 17th, 2010, 8:42 pm
Location: Marshall, Minnesota

BRIAN Z!

Post by ADC »

Hey, man, I had a question for you about 3DEM and Terrain Assist. I'm following your tutorials, but when I load the course architect file after following all the steps, I get this weird rippled architect file. I have no clue what I'm doing wrong. Can you help me out?
Attachments
ripples.jpg
(163.09 KiB) Not downloaded yet
"It is all good and well to punish a bad shot, but the right to eternal punishment should be reserved for a higher tribunal than a Green Committee." Bernard Darwin on Pine Valley Golf Club.
BrianZ111
Legend of Golf
Posts: 1017
Joined: November 12th, 2010, 12:59 pm
Location: Wisconsin
Contact:

Re: BRIAN Z!

Post by BrianZ111 »

Yeah for whatever odd reason that'll happen when you try to just use the plot that opens when you open the architect to create the initial flat plot. Make sure you explicitly go to File > New first when doing that part.
ADC
Tour Contender
Posts: 305
Joined: November 17th, 2010, 8:42 pm
Location: Marshall, Minnesota

Re: BRIAN Z!

Post by ADC »

Thanks, man. I appreciate your input a lot.
"It is all good and well to punish a bad shot, but the right to eternal punishment should be reserved for a higher tribunal than a Green Committee." Bernard Darwin on Pine Valley Golf Club.
Post Reply